제품
설치 공구
| HS-AA031 | Carbide Tipped Spot Facing Installation Kit |
The carbide tipped spot facing installation kit includes all the necessary tools needed to accurately mount a vibration sensor onto the rotating machine. The packaged kit includes; tapping drill, taps, tap wrench and a spot facing tool, all presented in a compact portable box. There are three versions of the kit available to allow for different mounting threads; ¼, M6 and M8.
Vibration sensors are fast becoming an integral part of the condition monitoring process and are relied upon to provide an accurate analysis of the machines health. The correct mounting of the sensor is vital to ensure reliable, true readings. The best possible method of mounting a sensor is via a drilled and tapped hole directly to the machine housing. However, this method often encounters problems when the housing is not flat. The spot facing installation kit allows the engineer to install the sensor on a flat surface ensuring best practice mounting technique.
The spot face tool is available to order separately (part number HS-AA001), please contact us for further details.
| HS-AA001-1/4 | Carbide Tipped Spot Face Tool |
| HS-AA003 | Stud Mounting Adhesive |
- 2 part adhesive
- Quick cure
- Maximum temperature 100°C
- Typical tube will stick 25 studs
Fitting Instructions
To ensure that the accelerometer gives optimum performance it is important that care is taken when mounting the stud and accelerometer by following the instructions below:-
- Select a mounting position, in any plane, as close as possible to the vibration source
- Prepare a flat, smooth, unpainted surface larger than the base of the accelerometer
- Thoroughly clean the surface and the base of the glue stud with solvent
- Dispense required amount of Loctite Metal Adhesive Set onto a suitable tray. Mix thoroughly to an even colour. This should take no more than 1 – 2 minutes. Apply adhesive to the base of the stud and fit to the prepared surface. The adhesive will begin to set after a few minutes, but allow 1 hour for a full strength bond
- Before fitting the accelerometer to the stud, smear grease onto the mating surfaces to ensure good coupling to the accelerometer
- Fit the accelerometer to the stud and lightly tighten
- Loop the cable and cleat to the accelerometer body, then cleat the cable to a surface to minimise movement